PDA

View Full Version : making a pooltable



carvman
12-03-2003, 02:28 PM
Hi!!
Can someone help me how to measure up the diamonds on the rail?

pooltchr
12-03-2003, 03:05 PM
I'm sure someone will correct me if I'm wrong, but it should be 1/4 1/2 3/4 measuring along the cushion from the center of the pockets.

Anonamus
12-04-2003, 06:38 AM
Check out this site.

http://www.wpa-pool.com/rules-tablespecs.htm

NH_Steve
12-04-2003, 07:12 AM
They have very specific measurements that meet international standards. However, if your table is an odd size, it looks like you might need to adjust <blockquote><font class="small">Quote wpa-pool.com:</font><hr> 6. Rail and Cushion
The rail width must be between 4 [117.5 mm] and 7 1/2 inches [190.5 mm] including the rubber cushions. 18 sights (or 17 and a name plate) shall be attached flush on the rail cap with:

12 1/2 inches [31.75 cm] from sight to sight on a 9-foot regulation table
11 1/2 inches [29.20 cm] from sight to sight on a 8-foot regulation table.

The center of each sight should be located 3 11/16 (+ ) inches [93.7 mm (+ 3.175 mm)] from the nose of the cushion. The sights may be round (between 7/16 [11 mm] and 1/2 inch [13 mm] in diameter) or diamond-shaped (between 1 x 7/16 [28.5 x 11 mm] and 1 1/4 x inch [32 x 16 mm]). Any nameplates and score counters should be flush level with rail top. All rail bolts should be thus located that when properly torqued render a quiet and optimum rebound from any point of the cushion nose of the table.<hr /></blockquote>

carvman
12-05-2003, 04:48 PM
Thank U !!!!!!!!!!!!

carvman
12-05-2003, 04:52 PM
1000 thanx ))))) /ccboard/images/graemlins/smile.gif /ccboard/images/graemlins/smile.gif