PDA

View Full Version : Plating table parts?



ballbanger
04-13-2005, 04:58 AM
Has anyone ever had the corner and side castings on their table re-plated? I am refinishing a G/C that had copper plated trim and is worn pretty bad. Does anyone know what it would cost to have them redone or a price on new parts? I am thinking of powdercoating as an alternative. Probably won't look as good but it would be quicker, easier & cheaper. Any suggestions?

Rich R.
04-13-2005, 06:43 AM
<blockquote><font class="small">Quote ballbanger:</font><hr> Has anyone ever had the corner and side castings on their table re-plated? I am refinishing a G/C that had copper plated trim and is worn pretty bad. Does anyone know what it would cost to have them redone or a price on new parts? I am thinking of powdercoating as an alternative. Probably won't look as good but it would be quicker, easier &amp; cheaper. Any suggestions? <hr /></blockquote>
There are companies all over the country that do plating.
Check your "Yellow Pages" and find one near you. Contact them and ask for an estimate.